Table of Contents
Advertisement
Next steps
1. Install the
system
board.
2. Install the heatsink.
3. Install the
right
fan.
4. Install the
left
fan.
5. Install the Battery.
6. Install the
VPU
card, for systems shipped with a VPU card.
7. Install the
M.2 solid-state
8. Install the
base
cover.
9. Install the
SD
card.
10. Follow the procedure in
Power button with fingerprint reader assembly
Removing the power button with fingerprint reader assembly
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
M.2 solid-state
5. Remove the
VPU
card, for systems shipped with a VPU card.
6. Remove the Battery.
7. Remove the
left
fan.
8. Remove the
right
fan.
9. Remove the heatsink.
10. Remove the
system
board.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
removal procedure.
drive, for systems shipped with a solid-state drive.
After working inside your
Before working inside your
drive, for systems shipped with a solid-state drive.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
113
Advertisement
Table of Contents
