5. Remove the
WLAN
card.
6. Remove the
WWAN
card.
7. Remove the battery.
8. Remove the
assembly inner
About this task
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Steps
1. Open the latch and disconnect the smart card reader cable from the connector on the USH board.
2. Remove the two screws (M2x3) that secure the smart card reader to the palm-rest assembly.
3. Lift the smart card reader off the palm-rest assembly.
Installing the smart card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
64
Removing and installing components
frame.