Table of Contents
Advertisement
Steps
1. Remove the two (M1.4x4) T5 Torx screws that secure the display FPC cover in place.
2. Flip open the display FPC cover.
3. Remove the two (M1.4x4) T5 Torx screws that secure the display FPC cable in place.
4. Disconnect the display FPC cable from the connector on the system board.
5. Remove the interposer board from the computer.
CAUTION:
Technicians must remove the interposer board immediately after disconnecting the display FPC
to prevent the board from falling out of the computer during subsequent removal procedures. The pins on
the interposer board are very fragile. Avoid contact with the pins on the board, instead handle the board by
lifting and holding from the edges or the sides.
64
Removing and installing Field Replaceable Units (FRUs)
Advertisement
Table of Contents
