Vega VEGAMIP R62 Operating Instructions Manual page 34

6 Setup
Fig. 30: Indication strip
1 Indication (LED indication strip)
2 More sensitive - Key to the left
3 Less sensitive - Key to the right
A Medium: Plastics (PP, PVC ...), solvents
B Medium: Building materials (sand, stones ...)
C Medium: Conductive substances (coal, ore, salt ...)
Receive level
Medium provides good
signal damping
34
1
A
2
Set the indication approximately to the middle of the LED indicating
board until the yellow status indication changes condition.
Depending on the vessel size, process and/or medium, you have
to adjust the sensitivity of VEGAMIP 62 to more or less sensitive. In
products with weak signal damping, in small vessels or pipelines or
with buildup, it might be necessary to test the switching function.
By means of the LED indicating strip, you can see the actual receive
level during adjustment.
When the indication moves to the right, the instrument is less sensi-
tive, to the left more sensitive.
In applications with products providing good signal damping (for ex-
ample rocks, ore, sand, cement) and where buildup and contamina-
tion is expected, you should adjust the instrument to more insensitive.
In this case, the VEGAMIP 62 switches only when there is a relatively
strong signal damping by the medium. Buildup does not influence the
measurement.
In case of buildup, press the key (to the right) until the flashing LEDs
are at the right edge of the LED indicating strip. For strong buildup,
you can press the key several times to make the instrument less sen-
sitive. The indication of the LED indicating strip does not change, but
the instrument will become a little less sensitive with each pressing of
the key.
1
B
3
VEGAMIP R62 • Receiving unit
1
C