Vega VEGAMIP R62 Operating Instructions Manual page 23

Wall mounting - External
housing
VEGAMIP R62 • Receiving unit
1
Fig. 19: Possibilities for signal deflection
1 Metal plate for deflection of the microwave signal
2 Bent antenna extension
3 Polarisation marking
1. Mark the holes according to the following drilling template
2. Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
Fig. 20: Hole pattern - wall mounting plate (external housing)
Tip:
Mount the wall mounting plate in such a way that the cable gland of
the base points downward. Rain and condensation water can thus
drain off.
The base of stainless steel can be displaced in 90° increments on the
wall mounting plate, the base of plastic by 180°.
Turn the cable gland of the electronics housing downward. The hous-
ing can be turned by 330° without the use of any tools.
3
2
90 mm
(3.54")
70 mm
(2.76")
3mm
(0.12")
4 Mounting
8 mm
(0.32")
23