Accessories - Vega VEGAMIP R62 Operating Instructions Manual

3 Product description
Storage and transport
temperature
Lifting and carrying
Protective cover
Flanges
Mounting adapter "Abra-
sion protection"
Mounting adapter "High
temperature"
10
•
Dry and dust free
•
Not exposed to corrosive media
•
Protected against solar radiation
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
•
Relative humidity 20 ... 85 %
With instrument weights of more than 18 kg (39.68 lbs) suitable and
approved equipment must be used for lifting and carrying.
3.4

Accessories

The instructions for the listed accessories can be found in the down-
load area on our homepage.
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ASME B 16.5,
JIS B 2210-1984, GOST 12821-80.
In case of extremely abrasive conditions you can cover the emitting
and receiving units with a ceramic abrasion protection. This mounting
adapter "Abrasion protection" is screwed onto the thread of VEGAMIP
62 like an adapter.
The mounting adapter "Abrasion protection" can only be used with
the threaded version (internal horn antenna with PTFE cover)
Fig. 3: VEGAMIP 62 with ceramic mounting adapter "Abrasion protection"
-40 ... +80 °C (-40 ... +176 °C)
With high process temperatures exceeding 80 °C, you have to use a
mounting adapter "High temperature" for the emitting and the receiv-
ing unit. The mounting adapter "High temperature" can only be used
with the threaded version (internal horn antenna with PTFE cover).
Fig. 4: VEGAMIP 62 with mounting adapter "High temperature" -40 ... +450 °C
(-40 ... +842 °F)
x Length: Mounting adapter "High temperature"
x
VEGAMIP R62 • Receiving unit