Arc Control Settings - Miller Big Blue 600 Air Pak Owner's Manual

6-6. Arc Control Settings

.
Arc Control is not active when the Process/Contactor switch is in the following positions:
Electrode Hot − CAC-A (Air Carbon Arc Gouging)
Remote ON/OFF GTAW (Remote TIG)
.
Miller recommends Hobart filler metals.
Process/Contactor Switch
OM-279640 Page 44
.
Complete Parts List available at www.MillerWelds.com
Arc Control
SOFT
(−25 to −1)
L (0)
STIFF
(1 to 25)
Voltage sensing feeder
SOFT
(−25 to −1)
L (0)
STIFF
(1 to 25)
SOFT
(−25 to −1)
L (0)
STIFF
(1 to 25)
STOP
(−5 to −1)
L (0)
STOP
(1 to 5)
Starting point for stainless steel wire (high inductance)
SOFT -12
Starting point for mild steel wire
Starting point for aluminum wire (low inductance)
STIF 12
Flat or horizontal welds with XX18 electrode with short weld cables
Starting point for XX18, XX13, XX14, XX24, and XX22 electrodes
Minimizes stickiness with XX18, XX14, XX22, XX24, and XX13
electrodes.
Softer, more slowly responding arc
Starting point for XX10 electrode/open root vertical down joint
Stiffer, more rapidly responding arc
Auto-Crater off (see Section 6-5). More sensitive Auto-Stop
Starting point.
Less sensitive Auto-Stop
Lift-Arc start. No Auto Crater allows full control on pipe welds with
short or long arc length. Auto Stop feature allows arc to be broken
without loss of shielding gas.