SOLTEK NV400-64 Manual page 62

NV400-64 / NV400-L64
KB Power On Pass-
Hot Key Power ON Allows you to set the hot key to boot up the system.
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial port 2 on your system may offer a va-
RxD , TxD Active The option controls the speed between receiving and
IR Transmission Delay When UART Mode is selected in IrDA or ASKIR
UR2 Duplex Mode This options controls the operating mode between
If Keyboard Power-on function is set at "Password",
word this item shows up to allow you to type a password
for the power-On function.
Choices: N/A; Password
Select Enabled if your system has a floppy drive
controller (FDC) installing in the system board and
you want to use it. If you install add-in FDC or the
system has no floppy drive, select Disabled in this
field.
The choices: Enabled; Disabled
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
Choices: Disabled; Auto;
3F8/IRQ4; 2F8/IRQ3;
3E8/IRQ4; 2E8/IRQ3
riety of infrared port modes. Click here for a de-
scription of various modes.
The choices: Normal(default); IrDA; ASKIR
transmitting of IrDA or ASKIR when using.
Choices: Hi,Hi; Hi,Lo; Lo,Hi; Lo,Lo
mode, it allows you to enable / disable IR Transmis-
sion Delay.
receiving and transmitting of IrDA or ASKIR. The
operating mode will be synchronous bi-directional
transmission and reception when Full mode is
selected. Nevertheless, the operating mode will be
asynchronous bi-directional transmission and recep-
tion when Half mode is selected.
The choices: Half; Full
66