SOLTEK NV400-64 Manual page 65

ACPI Function Select Enabled(default) only if your computer's op-
ACPI Suspend Type This item allows you to select the ACPI Suspend
Power Management This option allows you to select the type (or degree)
Maximum power savings. Inactivity period is 1 minute in each mode.
Max Saving
Set each mode in dividually. Select time-out period in the section for each
User Define
mode stated below.
Minimum power savings. Inactivity period is 1 hour in each mode (except the
Min Saving
hard drive).
Video Off Method This determines the manner by which the monitor is
V/H
SYNC+Blank
Blank Screen
This option only writes blanks to the video buffer.
Select this option if your monitor supports the Display Power Management
DPMS Support
Singaling (DPMS) standard of the Video Electronics Standards to select video
power management values.
HDD Power Down When enabled and after the set time of system
erating system supports the Advanced Configura-
tion and Power Interface (ACPI) specification.
Currently, Windows NT 5.0 ( Windows 2000 )sup-
ports ACPI.
type. You can select S3(STR) for Suspending To
RAM if your system supports this mode. Or you can
select S1(POS) for Power On Suspend under ACPI
mode.
Choices: S1(POS)(default);S3(optional); S1&S3
(Optional)
of power saving for Doze, Standby, and Suspend
modes.
This table describes each power management
mode:
blanked.
This selection will cause the system to turn off the vertical and horizontal
snchronization ports and write blanks to the video buffer.
inactivity, the hard disk drive will be powered down
while all other devices remain active.
69
Chapter 4 BIOS Setup