SOLTEK NV400-64 Manual page 63

Chapter 4 BIOS Setup
Use IR Pins When UART Mode is selected in IrDA or ASKIR
mode, this item allows you to select the IR Pins
signal selection.
The choices: IR-Rx2Tx2; RxD2, TxD2
Onboard Parallel Port This item allows you to determine onboard parallel
port controller I/O address setting.
The choices: 378H/IRQ7(default); 278H/IRQ5; 3BC/
IRQ7; Disabled
Parallel Port Mode Select an operating mode for the on-board parallel
(printer) port. Select Normal, Compatible, or SPP
unless you are sure your hardware and software
both support one of the other available modes.
Choices: SPP(default); EPP; ECP; ECP+EPP; Nor-
mal
EPP Mode Select Select EPP Mode when you choose EPP or
ECP+EPP mode in the Parallel Port Mode.
Choices: EPP1.7; EPP1.9
ECP mode Use DMA Select a DMA channel for the port when you choose
ECP or ECP+EPP mode for the Parallel Port Mode.
Choices: 1; 3
PWRON After PWR- This item is to set the mode to power on when power
Fail resumes after power fails.
Choices: Off(default) ; On; Former-Sts
Game Port Address This item allows you to select the Game Port
Address.
The choices: Disabled, 201(default), 209
Midi Port Address Allows you to configure the onboard Midi port
address.
The choices: Disabled, 290; 330(default), 300
Midi Port IRQ This item allows you to select the Midi Port IRQ.
The choices: 5, 10(default)
67