SOLTEK NV400-64 Manual page 57

System Performance Allows you to set different system performance
FSB Frequency Allows you to set the FSB Frequency.
CPU Interface This value will change in accordance of the setting
Memory Frequency This item allows you to set the Memory Frequency.
Resulting Frequency This item is to show the current DRAM Frequency.
Memory Timing This value will change in accordance of the setting
T(RAS) This value will change in accordance of the setting
T(RCD) This value will change in accordance of the setting
T(RP) This value will change in accordance of the setting
Cas Latency This value will change in accordance of the setting
FSB Spread Spectrum Allows you to enable (0.50%, 1.00%) / disable
AGP Spread Spectrum Allows you to enable (0.50%) / disable (Default) AGP
modes.
Choices: Optimal(default); Aggressive; Turbo; Ex-
pert
The Choices: 100MHz(default); 133MHz; 166MHz
of "System Performance".
Usually the resulting frequency will be decided by
the percentage setting multiplied by FSB Frequency.
SPD (Serial Presence Detect) is located on the
memory modules, BIOS reads information coded in
SPD during system boot up.
Choices: By SPD(default); Auto; 50%~200% (when
"System Performance" is set to "Expert")
of "System Performance".
of "System Performance".
of "System Performance".
of "System Performance".
of "System Performance".
(Default) FSB Spread Spectrum.This option can
reduce the EMI (ElectroMagnetic Interference) gen-
erated by the CPU.
Spread Spectrum.This option can reduce the EMI
(ElectroMagnetic Interference) generated by the
AGP.
61
Chapter 4 BIOS Setup