Kemppi FastMig X 350MV Manual page 20

Info
Restore Settings
EN
Licence Menu
WeldData Delay
Display Delay
Pre Gas Time
Post Gas Time
18
FastMig X 350MV
Shows following information about the selected device.
Device name:
DevSW: Unit software version.
SysSW: System software version (base software version).
BootSW: Boot software version.
SW Item: Software item number (IFS code).
Serial: Device serial number.
Prog: Programmer name
Date: Programming time and date.
User 1 (one of ten users) Channel:
Selected user can restore to his backup memory channels one by one.
Other users' memory channels remain untouched.
Setup settings remain untouched.
User 1 (one of ten users) All Channels:
Selected user can restore all of his backup memory channels (0-9) at one time.
Other users' memory channels remain untouched.
Setup settings remain untouched.
Restore To Factory:
All channels (of all users) are removed.
All users' backup channels are removed.
All setup settings are set to defaults.
When MMA/CC/CV Mode is selected, the Restore Settings options are:
MMA/CC/CV Channel
MMA All channels
Restore To Factory
Licence Code allows you to enter the licence code:
- Up and down arrows are used to select the code number position.
- Pulse encoder is used to select the code number (0–255) to be entered.
- Soft key button on the right is used to activate the licence number (after all numbers have been
entered). In case the code was wrong the earlier view will be displayed.
Licence Timers allows you to check the remaining time of the time-based Wise features.
1...60 s Step: 1
Factory Setting is 20 s.
1...20 s Step: 1
Factory setting is 10
0.0...9.9 s, CURVE. Step: 0.1
Factory settings is CURVE
0.0...9.9 s, CURVE. Step: 0.1
Factory settings is CURVE
Defines how long time the Weld Data is
displayed after welding ends.
Weld Data display is also turned off when
pulse encoder is turned or any button is
pressed.
Defines how long time the information is
displayed (e.g. "Setting Saved" text). This is
not always the exact time.
CURVE: Pre Gas time is read from the
Welding program.
0.0 – 9.9s: User Pre Gas time setting.
CURVE: Post Gas time is read from the
Welding program.
0.0 – 9.9s: User Post Gas time setting.