Scheppach Capas 7 Translation From The Original Instruction Manual page 20

Changing the Belts (fig. 28, 29)
Unplug the machine.
• Loosen the screws (1, fig. 28) and remove the belt cov-
er.
• Turn the screw (2, fig. 29) in an anti­clockwise direction
with an Allen key in order to move the motor forwards.
• Change the belts.
• Turn the screw (2, fig. 29) in a clockwise direction with
an Allen key to move the motor backwards. Do not over-
tighten.
• Replace the belt cover and tighten the screws.
Inspecting the Brushes
Check the new motor brushes for the first time after 50
hours of operation, after that every ten hours of operation.
Should the carbon be worn down to 6 mm or a feather or
wire be burned through or damaged, then both brushes
should be changed. Should it be determined when the
brushes have been removed that they can still be used,
then they can be replaced in the machine.
Conformity to EU Standards
We, scheppach Fabrikation von Holzbearbeitungsmaschin-
en GmbH, Günzburger Str. 69, D-89335 Ichenhausen,
state that the machine described in the following, based
on its construction and manner of assembly, as well as
the versions of the machine which we manufacture, is in
conformity with the pertinent regulations of the European
Union.
Should the machine be altered in any way, this statement
of conformity is made null and void.
Description of the machine
Crown and Mitre Box Saw
Machine Type:
Capas 7, Art.-Nr. 88001946
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Place, date:
Ichenhausen, 14.07.2009
Signed:
i.V. Wolfgang Windrich (technical director)
english 21