INSTALLATION
INSTALL HEATER INTO ENCLOSURE
1 .
Carefully move the heater into the enclosure, guiding the piping, flexible gas connection, and telescopic
,
extension tube into the access openings and through the appliance. Ensure that the air hose is not in a
position where it could get caught or crushed by the unit.
2.
Once the engine is in place reconnect the flue exhaust to the telescopic extension tube and secure together
with the pipe clamp.
3.
Secure the heater flange in place using 11 screws.
4.
Complete gas, air hose and flue connection. If vertically flueing ensure condensate tube, provided with the
ASPKIT03 flue kit, is attached to the condensate pipe on the heater - refer images below.
The unit is supplied with the heater condensate already connected.
NOTE
Flange screw position - 11 in total
Rinnai
Telescopic extension tube
Flue exhaust
The engine comes with the heater condensate already connected.
Flue locking clamp
Flue condensate pipe connection
32
RHFE 952/1253 OIM