Rinnai RHFE 952 ETRN Operation & Installation Manual page 35

Log fitting sequence (Cont.)
7. Front large middle log
Place onto the locating pin of log four and slot
onto the right front locating bracket.
9. Far LHS small log (RHFE 1253 only)
Fit the far small left hand log onto the two locator
brackets.
Adding the Granules
The granules as well as being added to create a more realistic log
flame affect (by diffusing the gas flames through the burner ports)
also assist in soot prevention and are CRITICAL to the performance
of the heater. Never pour the granules directly from the pack as dust
particles from the plastic bag may block the ports.
DO NOT place the granules near the flame rods or the pilot (areas
highlighted in the adjacent image) as this will cause a blockage and
the unit will not start.
Place the granules evenly (do not stack) around the logs in the front
part of the burner and on the middle section of the burner (in the
gaps between the logs)—refer fully assembled image.
Adding the Wire Wool
The wool is used to enhance the flame and is optional. Thin strands
of wire wool over the flames to makes them brighter and more
vibrant.
Take the wire wool out and tease into thin strands. Most installations
will use less than a third of the supplied wool. The remainder of the
wool can be left with the customer or can be used as a replacement
when the fire is serviced.
There is no benefit in having wool where there is no flame, and
having too much wool can make the flames too yellow and streaky.
Be careful to avoid getting the wire wool anywhere near the flame
rod as it may short it out.
Rinnai
8. Top upper right large log
Place onto the locating pin of log seven and
swivel OVER log 4. The end rests in burner slot.
10. Far RHS small log (RHFE 1253 only)
Fit the far small right hand log onto the two
locator brackets.
35
INSTALLATION
RHFE 952/1253 OIM