Rinnai RHFE 952 ETRN Operation & Installation Manual page 37

Stones RHFE-952 (cont)
3. From the stone set identify the six L1-L6
large grey stones.
5. Start placing the remaining stones on
the burner, starting at the front—8 stones
(identified with a dot).
7. Place the remaining 5 grey stones
(identified with a dot) through the middle
section of the burner. You may need to
tweak the position of the other stones for
them to fit and sit properly.
Rinnai
BURNER MEDIA INSTALLATION
4. Place the six large grey stones on the
middle and back sections as shown
below.
6. Place remaining grey stones on the back
section of the burner—6 stones (identified
with a dot).
8. Add the
Never
from the pack as dust particles from
the plastic bag may block the ports.
Place the granules evenly (do not
stack) around the stones with particular
attention to the front burner. Ensure there
are no granules placed directly over the
burner ports to the front and back of the
pilot burner or on the flame rods as this
may cause a blockage.
37
granules and wire
pour the granules
RHFE 952/1253 OIM
wool
directly