Rinnai RHFE 952 ETRN Operation & Installation Manual page 38

BURNER MEDIA INSTALLATION
Stones RHFE-1253
Arrange the rest of the logs and place 31 granules around the burner ports (not directly over)
as shown below. You will have granules left over.
CO = cutout stones
1. From the stone set identify the five front
grey cutout stones and place on the burner
brackets as shown below.
3. Start placing the small-mid sized stones on
the burner, starting at the front—11 stones
(identified with a dot).
5. Add the granules. Refer step 8 on previous
page, and image below.
DO NOT place the granules directly in front of the pilot flame
If there are some abnormally long streaky flames, then readjust the granule position
around the burner holes until the flames have improved.
Rinnai
L1-L8 = large grey stones
x 8
2. From the stone set identify the eight L1-L8
x 9
large grey stones and place on the burner
as shown in above and below images.
4. Place remaining stones (identified with a
dot) in the gaps. Some adjustment may be
required.
6. Add the wire wool - Refer note on the
bottom of p.20, and image below.
38
x 7
x 7
RHFE 952/1253 OIM