Hayward OmniPL HLBPRO4SW Operation Manual page 40

Exit Simple Mode
To exit Simple Mode, follow the procedure below.
The OmniPL should have already been configured for use with the home's router to allow for
remote control through the web. This procedure is covered in the Configuration Wizard information
found in the Installation manual. After configuration, an account must be created to allow access
to the OmniPL from web enabled devices. If this has not already been done by the installer, follow
the procedure below.
1. Using an ordinary web browser, go to www.haywardomnilogic.com. If you don't already have
an account, select "Register New User" and set up a new account.
2. Log in to your account.
3. Register your OmniPL. Registering will require you to answer a series of questions about
your OmniPL. When asked for your Time Zone, be sure to enter the same time zone as the
physical location of the installed OmniPL, otherwise schedules will be inaccurate. You'll also
be asked for an MSP System ID. This number can be found directly from the OmniPL. To find
your unit's MSP ID, follow the procedure below.
39
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
service
shut down
mode
vsp
heat/cool
daylight cleaner
Web Enabled Control
****
1 2 3
4 5 6
7 8 9
ENTER
password
features standard
o mode
.
0