Hayward OmniPL HLBPRO4SW Operation Manual page 4

This manual assumes that the OmniPL has been installed and configured according to the Installa-
tion Manual and is using the latest firmware version available from Hayward. The OmniPL can now be
programmed with user desired settings such as schedules, themes, and favorites. This manual will
also explain how to manually turn pool equipment on/off, program settings for specific equipment,
view pool equipment status and conditions, and more.
Now that the initial configuration has been completed, the OmniPL will automatically go to the Home
Screen or Idle Screen. All settings and operation functions can be accessed from the Home Screen.
Note that if the OmniPL Controller is not touched for more than two minutes, the Idle Screen will be
displayed.
Using the Controller
The OmniPL uses a local touchscreen terminal as the main interface with the device. Once config-
ured, the OmniPL can be controlled remotely using various Hayward remote terminals or, when con-
nected to the home's network, by Internet enabled devices such as computers, tablets and phones.
The Controller must be used to access the Configuration Wizard. The Configuration Wizard is used
for initial configuration (completed during the installation process) and for any changes to existing
configuration.
Idle Screen
The OmniPL Controller will display the idle screen after two minutes of user inactivity. When the
filter pump is on, the Idle Screen will display the current temperature of the Body of Water shown in
the upper left corner. If the OmniPL is configured to control two Bodies of Water, the idle screen will
toggle between both. On the right side of the screen, the air temperature will toggle with the date.
3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Introduction
13
82
F
º
9:13 PM
FRIDAY
jul 13