Hayward OmniPL HLBPRO4SW Operation Manual page 19

pH Calibration
If the OmniPL pH reading differs from independent water tests, you can adjust the reading by touch-
ing the Calibrate button and using procedure below. You'll be asked for the difference between the
displayed pH level and the true pH level. You'll want to select the amount needed to go from the
displayed level to the true level. In the example below, the displayed level is 7.3 and the true level is
7.5. You need to add .2 to the displayed level to arrive at the true pH level.
Calibrate reading from 7.3 to 7.5
ON
7.3
ColorLogic Lights
You can set schedules for the ColorLogic light as well as a countdown timer. This procedure has
been shown previously. Note that after the countdown interval, the lights will go off regardless of
their previous state.
vsp pH
heat/cool cleaner
POOL
features
Light Show/Color - From the ColorLogic Control Screen, select the desired show or color. Use the
Advance button to show all of the available selections. Use the Light Show/Color button to switch
between all light shows and all solid colors.
Synchronize - Because changing colors and shows requires interrupting power to the ColorLogic
lights, there is a chance that the lights could lose synchronization due to timing issues. If you find
that the color or show does not correspond with the selection that you've made, the lights may be
out of sync. Touch the Synchronize button to re-sync the ColorLogic lights.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
7.3
Dispensing On
7.3
1 / 2
alarm light row
uclights chlorinator
ON
7.5
.2
7.3
.2
ON
7.3
Dispensing On
7.5
Dispensing On
7.3
18