Hayward OmniPL HLBPRO4SW Operation Manual page 11

Set Pump Speed
Refer to the screen below to select the pump speed during the schedule. If custom is selected,
you'll be asked to set the % pump speed or RPM depending on the setting. When finished, touch
the Save button to save the schedule. NOTE: the speed setting only appears if the pump is a vari-
able speed or a two speed pump.
low med
custom
POOL
vsp pump
After saving, you'll be brought back to the pump schedule screen. The new schedule will be dis-
played.
NOTE: if you intend to run the pump at different speeds throughout the day, create additional
schedules. You can start a new schedule on the same minute that the previous one ends. If
schedules overlap, the newest schedule's start time will take priority by ending the previous sched-
ule early. You can create up to 100 total schedules on the system.
Edit a Schedule
To edit a schedule, touch the schedule as shown below. You'll be brought back to the screen which
will allow you to set times, speed and frequency.
01 10:00 am / 7:00 pm
POOL
vsp pump
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
start / end
repeat
high
speed
med all week
ON
10:00 am / 7:00 pm
01
POOL
vsp pump
start 10:00 am end 7:00 pm
:
10 00
POOL
vsp pump
all week
med ON
start / end
repeat
am
speed
pm
10