Hard Disk Error Messages - Epson Equity LT-386SX User Manual

Press Y and Enter to start the test. Press N and Enter to stop
the operation.

Hard Disk Error Messages

The program displays two types of error messages while testing
the hard disk: messages the program itself generates and those
the controller generates.
The following message appears if you attempt to run the
Performance Test with less than 128KB of memory:
INSUFFICIENT MEMORY FOR DATA TRANSFER
Minimum memory required is - 128KB
The controller displays one of the following messages when an
error
Address mark not found
Attachment failed to respond
Bad ECC on disk read
Bad sector flag detected
Controller has failed
Drive activity failed
ECC corrected data error
Requested sector not found
Reset failed
Seek operation failed
Write fault on selected drive
When you see one of these error messages, check the drive,
controller, cables, and power connectors. Remove and reinstall
the hard disk cartridge. If you still get an error, contact your
dealer.
D-30
System Diagnostics
occurs during a diagnostics procedure: