Epson Equity LT-386SX User Manual page 149

Type T and press Enter to run the selected tests in Timebound
mode. In Timebound mode, the program runs the tests for the
amount of time you specify.
Type C and press Enter to run the selected tests in Continuous
mode. In Continuous mode, the tests run until you interrupt
them.
Type P and press Enter to run the diagnostics tests in
Passbound mode. In Passbound mode, the program executes the
selected tests the number of times you specify. This is the
default setting.
The next prompt is:
Wait
Press Y and Enter if you want the program to pause when an
error occurs during a test. The program pauses and waits for you
to press Enter before continuing. This lets you view the error
message and make notes about the error. This is the default
setting.
Press N and Enter if you want the diagnostics program to
continue when an error occurs.
The next prompt is:
Error
Press Y and Enter to record the errors that may occur during
the test. See the "Error Logging" subsection for details.
Press N and Enter if you do not want to create the log. This is
the default setting.
If you decide not to wait on errors, you should select error
logging so you can review the errors that occur during the tests.
D-8 System Diagnostics
on error (Y/N) ? Y
logging (Y/N) ? N