Printer Problems - Epson ExpressStation User Manual

make sure you have write-enabled your computer's FLASH
memory. Check to see if a jumper is installed on pins 2-4 of
jumper block J5, as described in Chapter 3.
sure a jumper is installed on pins 1-3 of jumper block J21 to
enable you to run the program. See Chapter 3.
your software documentation or contact the manufacturer
for technical support.

Printer Problems

to the computer. (Also, be sure your printer has paper in it.)
switch or control panel settings.
one serial port, check the primary and secondary port
settings in the BIOS SETUP program or the System
Configuration utility to make sure they are correct. See
your
Software Guide
Software Guide.
indicates an error, contact your printer dealer.
If you are having trouble with a dot matrix printer, also try
running the printer diagnostic test.
Guide.)
for instructions.
If either the Parallel or Serial port test
your
(See Software
Troubleshooting
A-17