Removing A Drive From The Horizontal Position - Epson NX Service Manual

8
Run the SETUP program immediately to update the computer's configuration with the
new information.

Removing a Drive From the Horizontal Position

Follow these steps to remove a drive from a horizontal position:
1 Remove the computer's cover (see page 3-2).
2 Remove the drive ribbon cable and the power supply cable from the back of the drive.
3 Remove the two front retaining screws securing the diskette drive to the chassis. Then,
gently pull the drive out from the front of the bay as shown in Figure 3-9.
4
Keep the screws so that you can use them to install a drive later.
5 When removing the lower drive, replace the lower drive bay cover on the chassis and
on the front panel as shown in Figure 3-10.
6 If one of two hard disk drives is removed, the jumpers on the remaining hard disk
drive must be changed Check the hard disk drive documentation for details.
7 Replace the cover (see page 3-4).
8 Reconfigure the system with the SETUP utility before using the computer.
3-12
Figure 3-9 Removing/Installing a Horizontal Drive