Special Setting Mode - Horiba Scientific LAQUAtwin B-74 Series Manual

7

Special Setting Mode

The special setting mode enables the meter setting and special operations.
To enter the special setting mode, press and hold the MEAS switch for over
3 seconds in the measurement mode. All the LCD items appear, then the
meter enters the special setting mode.
Tip
To exit the special setting mode with no setting change, press the ON/
OFF switch to turn OFF and ON again.
Automatically
CAL switch*
CAL switch*
CAL switch*
CAL switch*
CAL switch*
All items
* Pressing the CAL switch continuously
appear. switches the display in turn.
** Example for B-742
**
(For B-741 and B-743, "kg/10a" always hides.)
MEAS
switch "7.1 Measurement unit setting" (page 19)
Used to select measurement unit.
**
MEAS
"7.2 Temperature display mode" (page 20)
switch
Displays the ambient temperature measured using an
internal temperature sensor.
MEAS
switch
"7.3 Calibration point setting" (page 21)
Used to select the calibration points.
"7.4 Multiplying compensation setting" (page 22)
MEAS
Used to select the coefficient (0.01 to 9.90) for
switch
multiplying compensation. The values after
compensation are displayed as results.
The initial setting is 1.00.
"7.5 Adding compensation setting" (page 23)
MEAS
Used to select the coefficient (1000 to 1000) for
switch
adding compensation. The values after compensation
are displayed as results.
The initial setting is 0.
17