Adding Compensation Setting - Horiba Scientific LAQUAtwin B-74 Series Manual

7.5

Adding compensation setting

Used to select the coefficient (1000 to 1000) for adding compensation. The
values after compensation are displayed as results. The initial setting is 0.
If measurement is affected by a known factor, change this setting as neces-
sary.
Note
The adding compensation function does not change the specified
measurement range or product performance.
1.
Press and hold the MEAS switch for over 3
seconds in the measurement mode to
enter the special setting mode.
All items appear on the LCD, and then the dis-
play changes as shown right.
2.
Press the CAL switch until
appear.
3.
Press the MEAS switch for 0.5 seconds.
The current setting is displayed.
4.
Press the CAL switch for 0.5 seconds to increase the value.
Pressing the CAL switch continuously increases the value in turn.
Pressing the CAL switch with 1000 displayed returns the value to 
1000.
Coef. = 0
Press the CAL switch
for 0.5 seconds.
Coef. = 1
5.
Press the MEAS switch to apply the setting.
The measurement mode is returned.
and b
CAL switch
CAL switch
23
Coef. = -1000
Press the CAL switch
for 0.5 seconds.
Coef. = 1000