Multiplying Compensation Setting - Horiba Scientific LAQUAtwin B-74 Series Manual

7.4

Multiplying compensation setting

Used to select the coefficient (0.01 to 9.90) for multiplying compensation.
The values after compensation are displayed as results. The initial setting is
1.00.
If the sample is diluted/condensed, change this setting as necessary.
Note
The multiplying compensation function does not change the specified
measurement range or product performance.
1.
Press and hold the MEAS switch for over 3
seconds in the measurement mode to
enter the special setting mode.
All items appear on the LCD, and then the dis-
play changes as shown right.
2.
Press the CAL switch until
appear.
3.
Press the MEAS switch for 0.5 seconds.
The current setting is displayed.
4.
Press the CAL switch for 0.5 seconds to increase the value.
Pressing the CAL switch continuously increases the value in turn.
Pressing the CAL switch with 9.90 displayed returns the value to 0.01.
Coef. = 1.00
Press the CAL switch
for 0.5 seconds.
Coef. = 1.10
5.
Press the MEAS switch to apply the setting.
The measurement mode is returned.
and A
CAL switch
CAL switch
22
Coef. = 0.01
Press the CAL switch
for 0.5 seconds.
Coef. = 9.90