Table of Contents
Advertisement
M0087369-08
Fuel System Secondary Filter -
Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over any
disconnected fuel system components.
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Note: The primary filter element must be replaced at
the same time as the secondary filter element. Refer
to Operation and Maintenance Manual, "Fuel System
Primary Filter (Water Separator) Element - Replace".
Fuel Filter with Canister
1. Close the fuel supply valve.
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
i08193624
NOTICE
NOTICE
Fuel System Secondary Filter - Replace
Illustration 82
Typical example
2. Clean the outside of the fuel filter assembly (1).
3. Remove setscrew (2).
4. Remove the canister (3). Ensure that any fluid is
drained into a suitable container.
Illustration 83
Typical example
5. Assemble the following items: new seals (8), new
seal (7), new canister (3), and bowl (10). Place
washer (5) and new seal (6) on setscrew (2).
99
Maintenance Section
g03317866
g02710378
Advertisement
Table of Contents
