Perkins 402J-05 Operation And Maintenance Manual page 9

Operation and maintenance manual
Table of Contents

Advertisement

M0087369-08
Start the engine from the operators station (cab).
Never short across the starting motor terminals or the
batteries. This action could bypass the engine neutral
start system and/or the electrical system could be
damaged.
Engine exhaust contains products of combustion
which may be harmful to your health. Always start the
engine and operate the engine in a ventilated area. If
the engine is in an enclosed area, vent the engine
exhaust to the outside.
Use caution when cover plates are removed.
Gradually loosen, but do not remove the last two
bolts or nuts that are at opposite ends of the cover
plate or the device. Before removing the last two
bolts or nuts, pry the cover loose to relieve any spring
pressure or other pressure.
Ensure that the correct lifting equipment is used
when lifting radiators, engines, engine components,
or batteries.
Pressure Air and Water
Pressurized air and/or water can cause debris and/or
hot water to be blown out. This action could result in
personal injury.
The direct application of pressurized air or
pressurized water to the body could result in personal
injury.
When pressurized air and/or water is used for
cleaning, wear protective clothing, protective shoes,
and eye protection. Eye protection includes goggles
or a protective face shield.
The maximum air pressure for cleaning purposes
must be below 205 kPa (30 psi). The maximum
water pressure for cleaning purposes must be below
275 kPa (40 psi).
Fluid Penetration
Pressure can be trapped in the hydraulic circuit long
after the engine has been stopped. The pressure can
cause hydraulic fluid or items such as pipe plugs to
escape rapidly if the pressure is not relieved
correctly.
Do not remove any hydraulic components or parts
until pressure has been relieved or personal injury
may occur. Do not disassemble any hydraulic
components or parts until pressure has been relieved
or personal injury may occur. Refer to the OEM
information for any procedures that are required to
relieve the hydraulic pressure.
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
Illustration 7
Always use a board or cardboard when you check for
a leak. Leaking fluid that is under pressure can
penetrate body tissue. Fluid penetration can cause
serious injury and possible death. A pin hole leak can
cause severe injury. If fluid is injected into your skin,
you must get treatment immediately. Seek treatment
from a doctor that is familiar with this type of injury.
Containing Fluid Spillage
Care must be taken to ensure that fluids are
contained during performance of inspection,
maintenance, testing, adjusting, and repair of the
engine. Make provision to collect the fluid with a
suitable container before any compartment is opened
or before any component is disassembled.
• Only use the tools that are suitable for collecting
fluids and equipment that is suitable for collecting
fluids.
• Only use the tools that are suitable for containing
fluids and equipment that is suitable for containing
fluids.
Ensure that any spill that may occur are clear-up
Safety Section
General Hazard Information
g00687600
9

Advertisement

Table of Contents
loading

Table of Contents