Perkins 402J-05 Operation And Maintenance Manual page 89

M0087369-08
Illustration 67
Typical example
2. Clean the sealing surface of the cylinder block or
the surface of the engine oil cooler if equipped.
3. Apply clean engine oil to the new O ring seal (2).
Do not fill the oil filters with oil before installing them.
This oil would not be filtered and could be contami-
nated. Contaminated oil can cause accelerated wear
to engine components or engine damage.
4. Install the new oil filter (1) Spin on the oil filter until
the O ring seal contacts the oil filter base. Rotate
the oil filter ¾ of a full turn.
Fill the Engine Crankcase
1. Remove the oil filler cap. Refer to the Operation
and Maintenance Manual for more information on
lubricant specifications. Fill the crankcase with the
correct amount of oil. Refer to the Operation and
Maintenance Manual for more information on refill
capacities.
If equipped with an auxiliary oil filter system or a re-
mote oil filter system, follow the OEM or filter manu-
facturer's recommendations.
overfilling the crankcase with oil can cause engine
damage.
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
g03380736
NOTICE
NOTICE
Under filling
To prevent crankshaft bearing damage, crank the en-
gine with the fuel OFF. This will fill the oil filters before
starting the engine. Do not crank the engine for more
than 30 seconds.
2. Start the engine and run the engine at "LOW IDLE"
for 2 minutes. Perform this procedure to ensure
that the lubrication system has oil and that the oil
filters are filled. Inspect the oil filter for oil leaks.
3. Stop the engine and allow the oil to drain back to
the sump for a minimum of 10 minutes.
Illustration 68
"ADD" mark.
(Y)
(A) Original oil level gauge
(B) Alternative oil level gauge
4. Remove the oil level gauge to check the oil level.
Maintain the oil level between the "ADD" and
"FULL" marks on the oil level gauge.
Engine Valve Lash - Check
This maintenance is recommended by Perkins as
part of a lubrication and preventive maintenance
or
schedule in order to help provide maximum engine
life. The maintenance for the valve lash is important
in order to keep the engine compliant.
Maintenance Section
Engine Valve Lash - Check
NOTICE
"FULL" mark.
(X)
89
g03306420
i05153520