Table of Contents
Advertisement
7.2. PARAMETER CONFIGURATION
Before using controller for the first time, parameters must be configured: rated voltage,
rated frequency, rated power set values must comply with the used generator, set C.T. ratio
value should comply to the used current transformer.
1)
When the controller is disconnected, press
from OFF to ON; after the controller is powered on release
windows (voltage window, frequency window and multifunctional window will show set
parameters; at the same time voltage window will start flashing showing four choices
(1P/2P/3P/4P) which mean 1P2W, 2P3W, 3P4W and Double Rated Volts respectively.
Use
and
the next menu item;
2)
Rated
voltage
(110/115/120/130/220/230/240V), use
(each pressing will increase/decrease the value for one step). When the screen shows
the needed value, press
3)
Rated power settings: power LED window first digit will start flashing; use
to choose a value from 0 to 9, then press
window second digit will start flashing, use
and
to confirm; power window third digit will start flashing, use
choose a value from 0 to 9 and
4)
Rated frequency setting: frequency LED indicator illuminates, multifunctional window
starts flashing; press
and 60Hz), every time you press the button the value will change; when the needed value
is displayed, press
5)
Auto protection setting: when auto protection light indicator is on, press
and auto protection will continue to be enabled; use
flashing and press
means that auto protection is disabled. Enabling this function is recommended;
6)
C.T setting: current LED indicator illuminates; multifunctional window first digit will start
flashing; use
and enter next settings; multifunctional window second digit will start flashing, use
and
to choose a value from 0 to 9 and
third digit will start flashing, use
to confirm and enter the next menu item;
7)
Engine temperature sensor type setting: when engine temperature indicator is on,
HGM501 Genset Controller User Manual
to choose AC wire type and
value
settings:
there
to confirm and enter the next menu item;
to confirm and enter the next menu item;
and
to choose frequency value (there are 2 choices: 50
to confirm and automatically enter the next setting;
to disable auto protection. When the light indicator is off, it
and
to choose a value from 0 to 9, then press
and
button, then change start key position
button and all the three
to confirm and automatically enter
are
7
possible
and
to switchover between them
to confirm and enter next settings; power
and
to choose a value from 0 to 9
or
to confirm; multifunctional window
to choose a value from 0 to 9 and
variants
of
voltage
and
and
to confirm
to make indicator
to confirm
Page 13 of 17
to
Advertisement
Table of Contents
