Hi-Hat Trigger Settings - Medeli MZ928 Owner's Manual

Trigger Settings
Scan Time 0.5 ~ 6.0ms The time it takes for the trigger signal to reach the peak level. If you find the volume level
Mask Time 0 ~ 64ms
Retrigger 1 ~ 16
Cancel
Position SW ON, OFF
Detailed special trigger settings of each pad:
Pad Name Trigger Parameters
KICK XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel
SNARE XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel,
Position SW
TOM 1 ~ 4 XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel
HI-HAT XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel
CRASH 1 ~ 2 XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel
RIDE XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel
EXT1 ~ 2 XTalk Cancel, Scan Time, Mask Time, Retrigger Cancel

Hi-hat Trigger Settings

1.
Press the [TRIGGER] button, then press the [F3] button to enter the Hi-
hat Trigger menu.
2.
Use the [CURSOR] dial to select a parameter, then use the [DATA] dial
to change the setting.
Parameter Range
SplashSens 1 ~ 8
HH Vibration 0 ~ 7
ClosePoint 91, 127
30
is not consistent when playing the drums at fixed velocity, you may adjust this setting. The
setting for different drum pads may vary.
Rise Time
Time
This setting is to prevent "re-triggering". For example, when the beater hits the kick pad, be-
cause of the bouncing force of the pad, it's very easy for the kick to be triggered again. You
can increase this value to prevent the occurrence of re-triggering.
Restrain Time
Time
It affects the decay of the trigger signal so as to prevent re-triggering caused by the vibration
of the pad. For example, when you strike a pad once, if you hear a small sound coming after
the main sound, you may in-crease this value.
Note: If the value is set too high, it becomes easy for some sounds to be omitted when play-
ing very fast.
Not Sounding
Time
Turn the position sensing function on or off (for the snare only).
Description
Adjust the hi-hat splash sensitivity. A higher value
makes it easy to produce the splash sound.
This setting is to prevent the vibration interfer-
ence caused by closing the hi-hat pedal. A higher
value makes it easy to prevent the interference.
Note: If the value is set too high, some sounds
may be omitted when playing the hi-hat.
Adjust the close point position.