Kit Reverb; Trigger Reverb; Kit Ifx - Medeli MZ928 Owner's Manual

Effect
Parameter Range
Trigger KICK, SNARE HEAD, SNARE RIM, TOM1, TOM2 TOM3,
TOM4, HI-HATBOW, HI-HAT EDGE, CRASH1, CRASH2,
RIDE, RIDE BELL, EXT1, EXT2
Q Mid: 0.1 ~ 12
Freq Low: 32 ~ 1.0k
Mid: 80 ~ 10.0k
High: 1.0k ~ 16.0k
Gain Low: -18 ~ +18 db
Mid: -18 ~ +18 db
High: -18 ~ +18 db

Kit Reverb

It recreates the reverberation and sound of the place where a drummer
performs.
1.
Press the [EFFECT] button, then use the [F2]/[F3] button, the [DATA]
dial or the [CURSOR] dial to select KIT REV. Then press the [F4] or
[SAVE/ENTER] button to enter this menu.
2.
In the Kit Rev menu, press the [F2] button to turn this effect on or off.
3.
Use the [CURSOR] dial to select a parameter, then use the [DATA] dial
to change the setting. You can press the [F4] button to preview the
effect.
Parameter Range
Reverb Type Hall, Room, Heaven,
Theater, Plate, Cloud
Level 0 ~ 127
Time 120ms ~ 90s
Tone -64 ~ +64
High Damp 0 ~ 128
Low Damp 0 ~ 128
Pre-Delay 0ms ~ 150ms

Trigger Reverb

You can adjust the reverb level of each pad and cymbal. The trigger
reverb level is affected by the kit reverb level.
1.
Press the [EFFECT] button, then use the [F2]/[F3] button, the [DATA]
dial or the [CURSOR] dial to select KIT REV. Press the [F4] or [SAVE/
ENTER] button to enter this menu.
2.
Press the [F3] button to enter the Trigger Reverb menu to adjust the
reverb level of each pad and cymbal.
Refer to similar operations on adjusting the parameters in the Mixer
chapter.

Kit IFX

You can set the IFX and adjust the effect parameters for each kit.
1.
Press the [EFFECT] button, then use the [F2]/[F3] button, the [DATA]
dial or the [CURSOR] dial to select KIT IFX. Then press the [F4] or
[SAVE/ENTER] button to enter this menu.
2.
In the Kit IFX menu, press the [F2] button to turn this effect on or off.
22
Description
Select the reverb type.
Adjust the reverb level.
Adjust the reverb time.
Adjust the reverb tone.
Adjust the high damping.
Adjust the low damping.
Adjust the pre-delay time.
Description
Select a pad or cymbal name.
Set the Q value of the Mid range.
Set the center frequency of the Low, Mid, High
range.
Set the gain of the of the Low, Mid, High range.