Adjusting The Tracking; Checking The Tire Pressure; Checking The Wheel Lug Nuts - Toro 74958 Operator's Manual

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward on
the left T-slot until the machine tracks straight
(Figure 60).
7. If the machine tracks to the left, loosen the bolts
and adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(Figure 60).
8. Tighten the stop plate
Figure 60
Left control lever shown
1. Control lever
2. Bolt
All manuals and user guides at all-guides.com
-
EUTRAL LOCK
and
AST
(Figure 60).
g027340
3. Stop plate

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the front and rear tires
at 90 kPa (13 psi). Uneven tire pressure can cause
uneven cut. Check the tires when they are cold to get
the most accurate pressure reading.
Checking the Wheel Lug
Nuts
Service Interval: After the first 8 hours
Yearly
Check and torque the wheel lug nuts to 122 to 136
N∙m (90 to 100 ft-lb).
50
Figure 61
g001055