Specifications - Toro 74958 Operator's Manual

switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
N - position.
EUTRAL LOCK
Ignition Switch
This switch is used to start the mower engine and has
3 positions: Start, Run, and Off.
Motion-Control Levers
Use the motion-control levers to drive the machine
forward and reverse, and to turn either direction.
Neutral-Lock Position
Use the N -
EUTRAL LOCK
safety-interlock system to engage and to determine
the N position.
EUTRAL
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
Electronic Control Unit
Malfunction Indicator Light
The electronic control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) illuminates.
The MIL is the red light located in the right console
panel.
Once the MIL illuminates, make initial troubleshooting
checks. Refer to the MIL section under
Troubleshooting (page
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
All manuals and user guides at all-guides.com
position with the
72).

Specifications

Note:
Specifications and design are subject to
change without notice.
Width:
Without Deck
Deflector Up
Deflector Down
Length:
Roll Bar - Up
Roll Bar - Down
Height:
Roll Bar - Up
179 cm (71 inches)
Weight:
Model
74958
15
135 cm (53 inches)
157 cm (62 inches)
192 cm (76 inches)
211 cm (83 inches)
215 cm (85 inches)
Roll Bar - Down
119 cm (47 inches)
Weight
532 kg (1172 lb)