Table of Contents
Advertisement
Starting and Stopping the
Engine
Starting the Engine
1.
Raise the ROPS up, lock it into place, sit on the
seat, and fasten the seat belt.
2.
Move the motion-control levers to the
N
-
position.
EUTRAL
LOCK
3.
Set the parking brake; refer to
Parking Brake (page
4.
Move the blade-control switch (PTO) to the O
position
(Figure
17).
5.
Move the throttle lever midway between the
S
and F
positions.
LOW
AST
Figure 17
All manuals and user guides at all-guides.com
Setting the
19).
g027412
6.
Turn the ignition key to the S
(Figure
18).
Note:
When the engines starts, release the key.
Important:
than 5 seconds at a time. If the engine fails
to start, wait 15 seconds between attempts.
Failure to follow these instructions can burn
out the starter motor.
Note:
You may need to attempt to start the
engine multiple times when you start it for the
first time after the fuel system has been without
fuel completely.
FF
1. Off
2. Run
21
position
TART
Do not engage starter for more
Figure 18
3. Start
g008947
Advertisement
Table of Contents
