Greasing The Mower - Toro 74958 Operator's Manual

Greasing the Mower

Service Interval: Every 50 hours—Grease the
mower-deck spindles and idler arm.
Yearly—Grease the pump-belt idler arm.
Yearly—Grease the front caster pivots (more
often in dirty or dusty conditions).
Yearly—Repack the front caster-wheel bearings
(more often in dirty or dusty conditions).
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Grease the mower-deck idler-pulley pivot until
grease come out the bottom
4. Grease the 3 spindle bearings until grease
comes out the lower seals
Figure 39
All manuals and user guides at all-guides.com
-
EUTRAL LOCK
(Figure 39).
(Figure 39).
g009029
37
5. Grease the drive-belt idler arm
Figure 40
6. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
complete. Refer to
Bearing (page 51).
7. Remove the hex plug and thread a grease fitting
into the hole.
8. Pump grease into the fitting until it oozes out
around the top bearing.
9. Remove the grease fitting from the hole.
10. Install the hex plug and dust cap
Figure 41
(Figure 39).
Adjusting the Caster-Pivot
(Figure 41).
g009030
g027413