Adjusting The Motion-Control Neutral-Lock Pivot; Hydraulic System Maintenance; Servicing The Hydraulic System - Toro 74958 Operator's Manual

With 60in side discharge mower
Hide thumbs Also See for 74958:
Table of Contents

Advertisement

Adjusting the
Motion-Control
Neutral-Lock Pivot
You can adjust the flanged nut to obtain the desired
motion-control lever resistance when you move them
to the N
-
position. See
EUTRAL
LOCK
adjustment options.
1.
Loosen the jam nut.
2.
Tighten or loosen the flanged nut to the desired
feel.
Note:
For more resistance, tighten the flanged
nut.
Note:
For less resistance, loosen the flanged
nut
3.
Tighten the jam nut.
Figure 82
1. Flanged nut
All manuals and user guides at all-guides.com
Figure 82
for
g008621
2. Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
oil or Mobil
®
1 15W-50.
Important:
Use oil specified. Other fluids could
damage the hydraulic system.
Each Hydraulic System Oil Capacity: 1.5 L (52 oz)
per side with filter change
Checking the Hydraulic Oil
Service Interval: Every 50 hours—Check the
hydraulic oil level.
1.
Position the machine on a level surface.
2.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
3.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4.
Wait for the engine and hydraulic system to cool
for 10 minutes.
Note:
The oil level on the dipstick is incorrect if
you check the oil when the machine is hot.
5.
Move the seat forward.
6.
Clean the area around the dipsticks of the
hydraulic system reservoirs
7.
Remove 1 dipstick from the hydraulic reservoir
(Figure
83).
8.
Wipe the dipstick off and thread the dipstick into
the reservoir.
9.
Remove the dipstick and look at the end
83).
Note:
If the oil level is at the add mark, slowly
pour only enough oil into the hydraulic reservoir
to raise the level to the full or H line.
Important:
Do not overfill the hydraulic
units with oil, as damage may occur. Do not
run the machine with the oil below the add
mark.
10.
Install the dipstick.
11.
Repeat procedure for the opposite dipstick.
61
®
HYPR-OIL
500 hydraulic
-
EUTRAL
LOCK
(Figure
83).
(Figure

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master commercial turbo force 3000 series

Table of Contents