Table of Contents
Advertisement
Section3
Setting the Logging Conditions
■ I/O RESULT
Set this item when you want to apply a trigger by the input result (e.g. trigger input)
from a controller on a specific CH assigned as the source or by the output result (HIGH/
PASS/LOW etc.).
FUN Mode-[LOGGING]-[TRIGGER]-[END]-[I/O]
SOURCE
I/O SEL
ACTIVE
■ HOUR
This item is for setting the time (hours, minutes, seconds) that logging is to end. Data
logging ends when the preset time is reached.
The system clock must be set on the ZS-DSU beforehand.
Setting the System Clock p.3-34
FUN Mode-[LOGGING]-[TRIGGER]-[END]-[HOUR]
<When set at 17:00:00>
16:00
ZS-DSU
3-24
User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting
Select the source to be used as the logging end trigger.
Range: SourceA to J
Select which I/O signal on the channel assigned as the selected source is
to be used as the start trigger.
Range: IN0 to IN3, OUT0 to OUT4
Sets the change in state of the signal, from ON to OFF or from OFF to ON,
to be taken as the trigger.
Range: OFF→ ON, ON→ OFF (default value: OFF→ ON)
16:30
17:00
17:30
Logging end
Description
ON
OFF
At OFF
ON
Logging end
At ON
OFF
Logging end
Advertisement
Table of Contents
