Step 4. Press the
a. Press the
•
Use the
b. Press the
•
Use the
number pad.
c. Press the
•
Use the
d. Press the
•
Use the
e. Press the
f. Press the
g. Press the
h. Press the
softkey to enter the Configure menu.
Figure 6.12 UART Config Menu
softkey to select Baud.
to set the baud rate.
Universal Knob
softkey to select Custom if Baud was set to custom.
Universal Knob
to set the baud rate or press the enter button to open the digital
softkey to select Data Length.
Universal Knob
to set the data length.
softkey to select Parity Check.
Universal Knob
to select the desired parity check.
softkey to navigate to page 2/2 of the Config menu.
softkey to select the Stop Bit.
softkey to toggle the Idle Level (Low or High).
softkey to toggle the Bit Order (LSB or MSB).
Serial Trigger and Decode
95