7 Address & Data
Triggers when the following conditions are satisfied:
•
The address's length must be 7 bits and the address's value is the same as set value.
•
If you have set either Data1's or Data2's value, and the signal has a data is the same as that value.
– If you have set both Data1's and Data2's value, the signal should has two consecutive data, the
first data's value is Data1, second data value is Data2.
If the data's value is 0xXX, any data value will be matched.
Figure 6.4 Restart,No Ack, and EEPROM Conditions
Figure 6.5 7 Address and Data
Figure 6.6 7 Address and Data2
Serial Trigger and Decode
84