B+K precision 2510B Series User Manual page 82

1. Press the then the
2. Press the softkey and select the desired slot (Decode1 or Decode2).
3. Press the softkey and then select I2C by turning the
4. Press the softkey to enter the I2C signal menu.
5. Set SCL (I2C's clock signal):
a. Press the
b. Press the first
Knob.
• The threshold voltage level is for decoding, and it will be regard as the trigger voltage level
when set the trigger type to serial.
6. Set SDA (I2C's data signal):
a. Press the
b. Press the
• The threshold voltage level is for decoding, and it will be regard as the trigger voltage level
when set the trigger type to serial.
SDA should keep stable during the whole high clock cycle, otherwise it will be
interpreted as a start or stop condition (data transitioning while the clock is high.
to enter the Decode menu.
Figure 6.1 I2C Decode Menu
Figure 6.2 I2C Signal Menu
softkey to select the channel that is connected to the I2C clock signal.
softkey to set the I2C clock signal's threshold voltage level by Universal
to select the channel that is connected to the I2C data signal.
softkey to set the I2C data signal's threshold voltage level by Universal Knob.
Serial Trigger and Decode
Universal Knob.
82