Trigger Logic; Probe Modes; Configurable Settings; Switch-On/Switch-Off Methods - Renishaw RMP40 Installation Manual

RMP40 installation guide

Trigger Logic™

Trigger Logic™ (see Section 4, "Trigger Logic™")
is a method that allows the user to view and select
all available mode settings in order to customise
a probe to suit a specific application. Trigger
Logic is activated by battery insertion and uses
a sequence of stylus deflections (triggering) to
2.2
systematically lead the user through the available
choices to allow selection of the required mode
options.
A Trigger Logic app is available that simplifies this
process with clear, interactive instructions and
informative videos and is available for download
on the following app stores.
or
Current probe settings can be reviewed by
simply removing the batteries for a minimum of
5 seconds, and then replacing them to activate
the Trigger Logic review sequence.

Probe modes

The RMP40 probe can be in one of three modes:
Standby mode: where the probe is awaiting a
switch-on signal.
Operational mode: activated by one of the
switch-on methods described on the next page. In
this mode the RMP40 is ready for use.
Configuration mode: where Trigger Logic may
be used to configure the probe settings.

Configurable settings

Switch-on/switch-off methods

The following switch-on/switch-off options are
user-configurable.
•
Radio on / radio off
•
Radio on / timer off
•
Spin on / spin off
•
Spin on / timer off