SpectraLink NetLink e340 Supplementary Manual page 8

If you have a previous mobility-domain configuration that is no longer valid, you must
clear the existing mobility-domain before a new one can be defined.
clear mobility-domain
# system will respond: success: change accepted
display mobility-domain config
# system will respond: there is no mobility domain
configuration
To check the mobility domain, use the following command:
display mobility-domain
The system will respond:
Mobility Domain name: default
Member
1.1.1.1
1.1.3.1
Checking the configuration
Once the switch is configured, issue the following command at the command prompt to
check the SVP settings:
display ap qos-stats
The following information should be displayed (repeat the command to see changes):
CoS
===========================
port: 1
1,2 Background
0,3 BestEffort
4,5 Video
6,7 Voice
port: 1
1,2 Background
0,3 BestEffort
4,5 Video
6,7 Voice
The switch and AP are now ready for use with NetLink Wireless Telephones.
The network topology and other functions can also be configured using the Mobility
System Software. Please refer to the 3Com Mobility System Software Configuration Quick
Start Guide or 3Com Mobility System Installation and Basic Configuration Guide for more
information.
PN: 72-9966-00-D.doc
State
STATE_UP
STATE_UP
Queue Tx
radio: 1
0
604
0
79106
radio: 2
0
0
0
0
SEED
MEMBER
# voice should have the most traffic
Page 8