SpectraLink Corporation
Message
Description
(battery icon),
Low battery.
Battery Low,
beep (audio)
Battery Failure
The Battery Pack is not functioning.
Battery Failed
Battery Pack is damaged or incompatible
with handset.
Cant Renew DHCP
y...y = DHCP server IP address
yyy.yyy.yyy.yyy
DHCP server is not responding to initial
renewal attempt.
Charging ...
The handset is charging in the Desktop
Charger.
Charge Complete
The handset is now fully charged
Checking Code
Handset is contacting the Download
Master to determine if it has a newer
version of software that should be
downloaded.
Checking DHCP IP
The handset is retrieving DHCP
information from the DHCP server.
CRC Code Error
The software which has been TFTP
downloaded has a bad redundancy code
check.
Code Mismatch!
The software loaded into the handset is
incorrect for this model handset.
DCA Timeout
The handset has detected a fault from
which it cannot recover, possibly due to a
failure to acquire any network.
PN: 72-1065-09-H.doc
Configuration and Administration–NetLink e340,/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
Action
In call: the battery icon displays and a soft
beep will be heard when the user is on the
handset and the battery charge is low. User
has 15–30 minutes of battery life left.
The Battery Pack can be changed while the
call is still in progress. Do not press Power
Off/End Call. Quickly remove the discharged
battery and replace with a charged battery,
power on the handset and press Power
On/Start Call to resume the call in progress.
Not in call: The battery icon displays whenever
the Battery Pack charge is low The message
Low Battery and a loud beep indicate a
critically low battery charge when user is not
on the handset. The handset will not work until
the Battery Pack is charged.
Replace the Battery Pack with a new or
confirmed SpectraLink Battery pack. Any non-
SpectraLink Battery Packs will not work.
Replace the Battery Pack with a new or
confirmed SpectraLink Battery pack. Any non-
SpectraLink Battery Packs will not work.
Configuration problem. Check the IP address
configuration in the DHCP server.
No action needed.
No action needed.
None, this message should only last for
approximately one second. If message
remains displayed, power off and contact
customer support for a replacement handset.
None. This is informational only.
Try the download again, it is possible the
software was corrupted during download. If
the error repeats, check that the download
image on the TFTP server is not corrupted.
Verify the License Management value is
correct. Replace the software image on the
TFTP server with software that is correct for the
handset model.
Turn the handset off then on again. If error
persists, contact SpectraLink Technical
Support and report the error.
Page 41
Need help?
Do you have a question about the NetLink e340 and is the answer not in the manual?