Power Off Your Projector - BOXLIGHT AYW502 Owner's Manual

Power off your projector

1. Press the Power button at the control panel
or the remote controller, then "Power off?"
message displays.
2. Press the Power button again within 4
seconds after the "Power off?" message
prompted to you. The POWER indicator
flashes red while the cooling fan continues
running. Unplug the power cord after the
fan stops running. Failure to do so may
shorten life cycle of your projector or lead
to power on failures or operation abnormali-
ties.
3. The POWER indicator stops flashing once
the projector has been cooled down to
ready for power on again.
To maintain the life cycle of the laser
!
light source, power off your projector
after it has been turn on for at least
five minutes.
Do not use your projector without
stop. As it may hurt the life cycle of
your lamp. Power off your projector at
least once every 24 hours and have
it idle for an hour.
Note:
● Speed of the cooling fan varies with internal temperature of your projector.
● Do not place your projector in any box before it is fully cooled down.
● In case the POWER indicator flashes or turns red, refer to the "LED indicator status" for
instructions. (Refer to page 75)
● The POWER indicator flashes when the lamp is cooling down. Do not power on your projector
at this time. Power on your projector only after the POWER indicator turns steady red.
● Unplug the power cord after your projector has been turned off. The fan stops running.
● The POWER indicator turns red when your projector is ready for power on again. It takes less
time to restart your projector after it was powered off in the standard power off procedure than
that of the non-standard one.
Basic operation
"Power off ? " disappears after 4 seconds.
Power off ?
27