Table of Contents
Advertisement
END------------------------------------
Setting a Single-Character Label ID
SR60 Scanner Programmer's Reference Manual
Chapter 3 — Configuring Label Transmit Settings
The scanner does not transmit a label ID character if its hex value
is set to zero. If you need a Label ID that contains only a single
character, you can set a single-character label ID.
To set a single-character label ID
1 Using the ASCII table on page 164, identify the ASCII
character and the corresponding hex code for the single-
character label ID.
For example, suppose you want to change the Label ID for
EAN-8 from the default setting FF to the single character 8.
The ASCII chart shows that ASCII 8 equals 38 hex.
2 Scan the SET bar code on page 63.
3 Using the bar codes in "Selecting the Symbology" on page 63,
scan the bar code representing the symbology whose Label ID
you want to change.
For this example, you would scan the EAN-8 bar code.
4 Using the list of bar codes that starts on page 160, scan the
two digits corresponding to the hex value you chose in Step 1.
5 Scan the 0 digit twice to disable transmission of a second
character.
For this example, you would scan 3, 8, 0, and 0.
Note: Successful programming requires four digits for the
label ID.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
67
Advertisement
Table of Contents
