Setting Up The Usb Interface; International Keyboard - Intermec SR61T1D User Manual

Setting up the USB Interface

SR61T Tethered Scanner User's Guide
4 Turn on your host device.
Note: If you are using a non-powered USB cable, you may get a
message that the host does not provide enough power. For
example when you connect the USB cable to a keyboard hub or
if there are other USB devices connected. In this case use a
different hub or disconnect other USB devices. Otherwise use a
powered USB cable.
5 If necessary, use the configuration bar codes in the next section to
configure your SR61T for an International keyboard. The default
keyboard is North America.
This section provides configuration bar codes for a basic USB
interface setup. All bar codes marked with (*) indicate the default
value. For more configuration options see
the SR61T" on page

International Keyboard

By default the SR61T uses the keyboard HID USB cable mode. Use
these configuration bar codes to select the keyboard for your country.
For additional keyboards see EasySet.
North American Windows (*)
French Canadian Windows 95/98
31.
French Canadian Windows XP/2000
Chapter 3 — SR61T Interfaces
Chapter 4, "Configuring
French Windows
23