Wand Emulation Pre/Post-Noise Settings
Pre-Noise Transitions Settings
SET-------------------------------------
Don't Transmit
Pre-Noise
Set Pre-Noise
Transitions
SR60 Scanner Programmer's Reference Manual
You can independently configure the number of noise transitions
generated prior to or following label transitions.
To disable transmitting pre-noise or post-noise transitions
1 Scan the SET bar code.
2 Scan either the Don't Transmit Pre-Noise bar code on this
page or the Don't Transmit Post-Noise bar code on page 18.
3 Scan the END bar code. You have disabled noise transitions.
To set pre-noise or post-noise transitions
1 Scan the SET bar code.
2 Scan either the Set Pre-Noise Transitions bar code on this
page or the Set Post-Noise Transitions bar code on page 18.
3 From the "Keypad Bar Codes" on page 160, scan two digits
that represent the appropriate number of noise transitions.
You can choose from one to twenty noise transitions for either
pre-noise or post-noise. For example, scan the 0 and the 3 bar
codes for three transitions.
4 Scan the END bar code.
---------
---------
Chapter 2 — Configuring Interface Settings
17